metal roof installation for Virgin homes, handled by a family roofing company that has been at it since 2002. Estimates are always free.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Virgin install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Our metal roof installation work in Virgin is handled by crews who do this every week, not by whoever happened to be free that morning. It shows up in the details — valleys, chimney flashing, eave and ridge closures — because that is where roofs actually leak.
We schedule your Virgin metal roof installation for a stretch of dry weather, keep the job site picked up as we go, and do not leave a roof open overnight. When it is done the tear off is hauled away and a magnet goes over the drive.
Four steps and no surprises. This is how we have done it since 2002.
Panel type comes first — standing seam or exposed fastener — then color, then trim. We walk you through the trade offs on each one.
If the shingles are coming off, they come off, and every board underneath gets checked before anything new goes down.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Every penetration gets a proper boot or flashing instead of a bead of sealant and a hope.
What comes up on just about every estimate for a job like this.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Virgin homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Sometimes. If the decking is sound and there is only one layer of shingles, a Virgin metal roof can go over the top on purlins. Two layers or rot underneath and we tear off first — and we say so before you sign.
Most Virgin metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
A straightforward Virgin house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
Honest words from customers, in their own wording.
"They reroofed the porch and matched it to the house so well you cannot tell where the old work stops and the new starts."
"Green metal over the whole house and the carport. Looks sharp, and it is quiet inside when it rains, which honestly surprised me."
"Burgundy metal roof on our brick ranch and I get compliments on it constantly. They brought the color chart out and let us take our time deciding."